Support Center

The JumpCloud Commands Gallery

The JumpCloud Commands Gallery contains curated Mac, Windows, and Linux commands that are available for import using the JumpCloud PowerShell module.

The JumpCloud PowerShell module is not required to leverage the commands in this gallery.

This library of JumpCloud commands is hosted on GitHub and maintained by the JumpCloud solution architecture and success teams.

Find quick links to navigate to sections of the JumpCloud Command Gallery below: To import these commands first install the JumpCloud PowerShell module.

Note this module can be installed on Mac, Windows, and Linux. 

Once the module has been installed find at the bottom of each command a code block under the header Import This Command.

Simply copy and paste the code from this section and run it in the PowerShell terminal to import the command into your JumpCloud tenant.

Imported commands will be located within the commands section of the JumpCloud admin console.

Alternatively, each command in the gallery can be created manually in the JumpCloud admin console by copying and pasting the code block under the Command header into a new command within the JumpCloud admin console.

Last Updated: Jul 23, 2018 07:59AM MDT

Related Articles
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found